Stainless covers
Stainless steel covers resist rust far better than galvanized steel without needing paint.
Chimney Parts
Chase Cover Replacement Swedesboro, NJ
A chimney sweep in Swedesboro can replace the metal cover on top of a framed chimney chase sized to the chase and shaped to shed water off the edges. Call (856) 490-5006 to reach a local chimney sweep.
If your chimney is covered in siding instead of brick, it is probably a chase built around a metal flue. The chase cover, sometimes called a chase top or chase pan, is the metal sheet that caps the top of that enclosure. Its job is to keep water out of the framing and away from the fireplace below.
Many chase covers installed by builders are made of galvanized steel, and they are often flat. A flat galvanized pan collects water, rusts through and stains the siding below. By the time rust streaks show up, water may already be getting into the chase.
Once water gets in, it can travel down the chase and into the fireplace. Rotted framing, wet insulation, rusted firebox parts and water stains inside the house are all common results. Catching a bad cover early keeps the repair simple.
Chase Cover Replacement is often paired with chimney cap installation and chimney leak repair, depending on the cause.
Need chase cover replacement in Swedesboro? Call (856) 490-5006 and describe the problem to a chimney sweep who works in Swedesboro.
Call nowThe process
What happens during a chase cover replacement
A chase cover has to be sized to the chase and the flue, so measuring comes first.
Inspect the chase
The chase is inspected from the roof for rust, holes and soft framing. Soft wood under the cover is a sign of a longer leak.
Take measurements
The chase top is measured, along with the flue opening and its position. A good fit matters more than anything else.
Pull the cap
The cap comes off first, then the old cover is unscrewed and lifted away. This is the best time to look for rot.
Fit the new top
The new cover is set in place with its skirt over the siding and a hem that kicks water off the edge. Fasteners are placed so they do not create new leaks.
Reinstall the cap
A sealed storm collar and cap close up the opening at the flue. The finished top is checked for gaps.
What is included
What chase cover replacement covers
Copper tops
A copper chase top adds a finished look and resists corrosion for homes where looks matter.
Storm collars
A new storm collar and cap finish the top for a complete watertight top.
Skirt hems
A hemmed drip edge on the skirt kicks water away from the siding and reduce staining.
Sloped tops
A sloped or cross broken top keeps water from pooling and keep the cover drier.
Related service
Chimney Chase Repair Swedesboro, NJ
Chase repair goes hand in hand with replacing a cover that has been leaking. Common repairs include replacing rotted framing and sheathing, fixing or replacing siding, resealing trim and replacing wet insulation. Flashing where the chase meets the roof is checked too.
When you call (856) 490-5006 from Swedesboro, mention where you have seen water or rust, since it helps locate the leak. Some chase repairs need carpentry, so ask how that work is handled. Rot under the cover needs attention before the new cover goes on.
Local help
Chase Cover Replacement Near Me
Chase covers in Swedesboro face every kind of weather the year brings, from summer storms to winter snow. Homes in Swedesboro and nearby towns such as Beckett, Mullica Hill, Gibbstown and Woodstown often have chase covers that were installed when the house was built and never replaced, so replacing an old cover before it fails saves a lot of repair work.
For chase cover replacement in Swedesboro, NJ or nearby towns like Beckett, Mullica Hill, Gibbstown and Woodstown, call (856) 490-5006 to reach a chimney sweep who covers your street.
What the local climate does to a chimney
Cold winters keep fireplaces, wood stoves and oil burners working for half the year or more. Masonry takes the worst of it from the freeze and thaw cycle: water soaks into brick, mortar joints and the crown on a mild day, freezes overnight and expands, and each winter widens the cracks a little more. Nor'easters drive rain sideways into flashing and mortar that looked fine in summer. That is why chimney cleaning in Swedesboro is usually booked in the fall, before the first cold night.
Why call
Why not wait
Smaller repairs
Small chimney problems caught early usually stay small repairs.
Sweeps who know Swedesboro
Local sweeps see the same chimney types and weather wear across Swedesboro and nearby towns.
Know what happens next
Ask the sweep about the cause, the options and the estimate before work starts.
Chase Cover Replacement questions
What is a chase cover?
The chase cover is the metal sheet that seals the top of a chimney chase, with an opening for the flue pipe. Its job is to keep water out of the framing, insulation and fireplace. The cap and cover work together to keep water out.
How long will a new chase cover hold up?
A stainless steel or copper chase cover can last for decades. A sloped design and drip edge help it last by keeping water moving. Inspections every year catch problems early.
Why is there water in my prefab fireplace?
Water from a leaking chase cover often runs down the flue pipe or framing and into the fireplace. It can lead to rust, damaged panels and stains around the fireplace. The sweep will check the cover, collar and cap to find the source.
Why is my chase cover rusting?
Many original chase covers are made of galvanized steel, which rusts once its protective coating wears away. Flat covers make it worse, since standing water sits on the metal. Those streaks are a sign the cover needs replacing.
Should I patch or replace my chase cover?
Small holes can sometimes be patched, but patches on a rusting galvanized cover rarely last. Replacing it with a sloped stainless or copper cover is the more lasting fix. The framing beneath should be checked while the cover is off.
More questions? Call (856) 490-5006
Related services
Chimney Cap Installation
Putting a sturdy cap on top of the chimney sized to the flue tile or the whole crown.
Learn moreChimney Leak Repair
Stopping chimney leaks at the source, before the water rots framing or ruins the flue.
Learn moreChimney Waterproofing
Treating chimney brick and mortar with a breathable water repellent, applied after repairs so the brick sheds water but can still dry out.
Learn moreChimney Repair
Fixing cracked crowns, failing mortar, loose brick, leaky flashing and damaged flue tiles, matched to what an inspection actually finds.
Learn more
Looking for something else?
See all chimney servicesNeed chase cover replacement in Swedesboro, NJ?
Call now for Swedesboro chase cover replacement and help in the towns around it.
(856) 490-5006
Free to call. No forms to fill out.