Hearth protection
Floor protection in front of the insert is confirmed to meet the listing so embers cannot reach flooring.
Fireplace Service
Fireplace Insert Installation Swedesboro, NJ
A fireplace insert is a closed stove or gas unit that slides into an existing firebox, and a Swedesboro installer can fit one so the fireplace actually heats the room. Dial (856) 490-5006 to be connected with a local installer for gas, wood or pellet inserts.
Open fireplaces are pleasant to sit by but poor at heating, because they draw large amounts of warm house air up the chimney. An insert closes the opening with a sealed door, controls the air supply and pushes heat into the room, often with a blower.
Before any unit is chosen, the existing chimney gets a close look. Industry practice treats an insert as a change to the system, the trigger for a Level 2 inspection that includes a camera look at the flue. Damaged tiles, mortar gaps or crown cracks are best repaired first, since the insert blocks access to the lower chimney.
Most inserts today are installed with a stainless steel liner that runs from the insert to the top of the chimney. An old masonry flue is often far larger than the insert outlet, which lets exhaust cool, draft poorly and leave heavy creosote. An insulated liner adds draft and safety, especially in a cold outside chimney.
Fireplace Insert Installation is often paired with chimney liner installation and gas fireplace repair, depending on the cause.
Dealing with this in Swedesboro, NJ right now? Call (856) 490-5006 and describe the problem to a chimney sweep who works in Swedesboro.
Call nowThe process
The insert installation process
Here is how an insert typically goes from first visit to first fire.
Chimney inspection
The installer examines the whole system, often with a camera up the flue. That inspection decides whether the chimney is ready.
Take measurements
Inserts are chosen by firebox size, so widths, height and depth are measured precisely. Mantel and trim clearances in the insert manual can rule some models in or out.
Install the liner
A full-length stainless liner goes in from the top, often wrapped in insulation, then capped at the top.
Connect the insert
The insert is slid into the firebox, connected to the liner and leveled. The decorative surround closes off the space around it.
Test burn
The insert is fired to check draft, door seal, blower and controls. Ask about break-in fires, which cure the paint and should be kept small.
What is included
What an insert installation includes
Top plate with cap
A plate seals the top of the old flue around the liner, finished with a rain cap so water and animals stay out.
Trim kit
A surround or trim kit covers the gap between the insert and the masonry and keeps room air from leaking up the flue.
Stainless steel liner
A liner sized to the insert outlet, run to the top of the chimney with insulation where it is needed.
Pre-install inspection
The chimney is checked for cracks, gaps and creosote ahead of time so the insert vents into a sound system.
Related service
Gas Fireplace Insert Swedesboro, NJ
For people done with hauling wood, a gas insert puts a sealed gas firebox inside the masonry fireplace. Most are direct vent, with two flexible aluminum liners run up the chimney, one bringing in outside air and one carrying exhaust out. Running the gas line is part of the job and is done to local code.
Gas inserts in Swedesboro are popular with homeowners who want heat at the push of a button and no ash to clean. Some ignition types can still light during a power outage, though the blower will not run. They still need a yearly service and vent check.
Related service
Wood Burning Insert Swedesboro, NJ
A wood burning insert is a steel or cast iron stove built to sit inside a fireplace, with a firebrick-lined firebox, a baffle and a tight-sealing glass door. New wood heaters sold in the US must meet EPA emission limits, so a modern insert makes much less smoke and creosote than an open fire when it is fed dry wood.
Wood inserts in Swedesboro work best with seasoned wood under about 20 percent moisture, since wet wood smolders and coats the liner with creosote. Yearly sweeping and inspection of the liner keep the system safe.
Local help
Fireplace Insert Installation Near Me
Many fireplaces in Swedesboro were built for looks as much as heat, with large clay-lined flues that suit an open fire but not a modern insert, so relining usually goes hand in hand with the insert. From Swedesboro to Beckett, Mullica Hill, Gibbstown and Woodstown, homes with exterior masonry chimneys gain the most from an insulated liner, since cold flues draft poorly.
For fireplace insert installation in Swedesboro, NJ or nearby towns like Beckett, Mullica Hill, Gibbstown and Woodstown, call (856) 490-5006 to reach a chimney sweep who covers your street.
How the weather here affects chimneys around Swedesboro
Winters here are long and cold, and the heating season usually runs from October well into April. Masonry takes the worst of it from the freeze and thaw cycle: rain and melting snow soak into the crown and joints, then freeze and push them apart, and each winter widens the cracks a little more. Wind driven rain from coastal storms finds any gap in flashing, too. Most homeowners in Swedesboro, NJ schedule a sweep in early fall, and a repair check after a hard winter.
Why call
Why not wait
Safer fires
A chimney problem fixed early rarely spreads to the masonry, the liner or the house.
Sweeps who know Swedesboro
Local sweeps see the same chimney types and weather wear across Swedesboro and nearby towns.
Clear next steps
Ask the sweep about the cause, the options and the estimate before work starts.
Fireplace Insert Installation FAQ
Can any fireplace take an insert?
The firebox has to be large enough and the chimney sound enough, which the measurements and inspection settle. Masonry fireplaces are the usual candidates, while factory-built metal fireplaces can only take an insert listed for that model. A visit with measurements settles it.
How do I maintain a fireplace insert?
Wood inserts need the liner swept at least once a year, along with ash removal, door gasket checks and a look at the baffle and firebrick. Gas inserts need an annual service of the burner, pilot, glass and vent. Either way, working CO alarms belong on every level of the home.
How long does it take to install a fireplace insert?
Most installs take about a day once the insert, liner and parts are on hand. Ordering the insert and finishing any chimney repairs first usually takes longer than the install. For gas models, the gas line work is part of the timeline.
Why does a fireplace insert need a liner?
Current practice and most insert manuals call for a full-length liner from the insert outlet to the top of the chimney. Without one, exhaust enters an oversized flue, slows down, cools and leaves creosote. A direct connection also lets the system be swept from the top.
Is a gas or wood burning insert better?
Which one fits comes down to fuel, effort and how much heat you want. Gas inserts offer push-button convenience and little upkeep but need a gas line. Wood gives strong heat and a real fire, at the cost of splitting, stacking and cleaning. Pellet inserts sit between them, feeding automatically but needing power.
More questions? Call (856) 490-5006
Related services
Chimney Liner Installation
Installing stainless steel or cast in place liners sized to the fireplace, stove, furnace or water heater it serves.
Learn moreGas Fireplace Repair
Diagnosing pilot, igniter, valve and venting faults on gas fireplaces, with the burner, glass and venting checked on every visit.
Learn moreWood Stove Installation
Wood stove installation into an existing chimney or a new insulated chimney, following the stove manual and local code.
Learn moreFireplace Repair
Fixing fireplaces that smoke, leak heat or show cracked masonry from the hearth and firebox to the damper and doors.
Learn more
Looking for something else?
See all chimney servicesTalk to a Swedesboro chimney sweep about fireplace insert installation
Call (856) 490-5006 for a local chimney sweep in Swedesboro and nearby towns.
(856) 490-5006
Free to call. No forms to fill out.